Pressurized, or Closed, Separators

 Modified Production Separators

The major advantages of a closed pressurized separators are that it
(1) controls gas from the well and sends it to a flare line under pressure and (2) is serviced by a special crew.


The separator is usually operated under 3 to 5 atmospheres of pressure
(45 to 75 psig). Horizontal units are typically about 9 feet in diameter
and 50 feet long, with a throughput of 5 MMcf or 500 bbl fluid. These are
typical numbers, and sizes and pressure vary according to special jobs.

Continue reading “Pressurized, or Closed, Separators”

Mud gas separator

Mud Gas Separator is commonly called a gas-buster or poor boy degasser. It captures and separates large volume of free gas within the drilling fluid. If there is a “KICK” situation, this vessel separates the mud and the gas by allowing it to flow over baffle plates. The gas then is forced to flow through a line and vent it to a flare. A “KICK” situation happens when the annular hydrostatic pressure in a drilling well temporarily (and usually relatively suddenly) falls below that of the formation, or pore, pressure in a permeable section downhole, and before control of the situation is lost.-wiki

Continue reading “Mud gas separator”

Drilling mud Gas Buster

Drilling mud gas buster also called a mud gas separator  or poor boy degasser. It captures and separates large volume of free gas within the drilling fluid. If there is a “KICK” situation, this vessel separates the mud and the gas by allowing it to flow over baffle plates. –wiki

The purpose of a gas buster is to remove gas mixed with the drilling fluid before the drilling fluid goes over the shale shaker. A gas buster works well in fluid with large bubbles of free gas. (Often the gas is starting to break free in the flowline.) A problem with the basic gas buster is that the heavier gases will not rise and be dissipated in the air but settle around the rig.

Continue reading “Drilling mud Gas Buster”