Tag: shale shakers

Posted on

Evaluate The Efficiency Of Solids Control Equipment

The volume and type of solids in a drilling mud system can adversely affect mud properties, reduce penetration rates, cause damage to drilling equipment, and increase total drilling costs. Efficiency controlling the solids content of the mud system is an important phase of an efficient and cost-effective drilling program. The three basic methods of removing solids are dilution and/or displacement of whole mud, settling and mechanical solids-control equipment.

Fig 1. Size capacity and operating of solids control equipment

Continue reading “Evaluate The Efficiency Of Solids Control Equipment”

Posted on

RIG PREPARATION FOR DRILLING OIL-BASED MUD

Oil-based drilling fluids have long been recognized as a sound technical answer to problems encountered in deep-hot holes and, more recently, to stabilize boreholes with thick intervals of reactive clay formations. However, oil-based mud product development was slowing down until the introduction of low toxicity base oils in the late seventies created a need for new investigations. This innovation sparked a resurgence of oil mud research and development which has resulted in oil-based mud (OBM) systems being used routinely in many active drilling areas worldwide.

Continue reading “RIG PREPARATION FOR DRILLING OIL-BASED MUD”

Posted on

Use of Rotating Separators as an Alternative to Shale Shakers

The rotating separator process is based on a different principle than the shale shaker process. The mud line flow is fed into the slowly rotating separator. The drilling fluid contaminated with drilled cuttings is fed into the centre of a screen coated drum as shown schematically in Fig. 1. The outside of the drum is connected to an under-pressurised ventilation system.

Continue reading “Use of Rotating Separators as an Alternative to Shale Shakers”